How It Works / Detailed Installation

A finished result starts with a better route.

A multifamily repipe is a building project, a resident project, and a plumbing project at the same time. The installation sequence is designed to keep those pieces coordinated.

The installation sequence

Five steps from assessment to handoff.

Each step below has one job: show what happens, what it establishes, and what the building looks like while the work moves forward.

The process begins with the building itself, then moves through resident preparation, occupied installation, finish work, and planned future access.

1

Assessment & Proposal

A site visit establishes the building conditions before the project is committed: the existing plumbing risk, the route, occupied-building constraints, scope, timeline, and cost.

What this step establishes
  • Existing pipe and building conditions
  • Route and access constraints
  • Scope, timeline, and project cost
Occupied multifamily residential building
Occupied multifamily building context. The assessment is about this kind of property, not a generic installation template.
2

Prepare the building

Scheduling and resident communication happen before work starts. Access, protection, staging, and work areas are set up so occupied homes are ready for the crew without turning the whole suite into a construction zone.

What this step establishes
  • Resident communication and access
  • Protected work areas
  • Staging before installation begins
Protected occupied-suite work area prepared for Plumbing Track installation
Protection and staging are in place before the crew moves through the occupied suite.
3

Install Around Occupied Homes

The route is worked through lived-in spaces and around the architecture that is already there. Access stays concentrated where the plumbing actually requires it, while the replacement system is installed through the planned path.

What this step establishes
  • Work continues in protected occupied spaces
  • Openings stay focused on required access points
  • New pipe follows the planned building route
New plumbing installed through a concentrated access opening
New pipe is installed through the access opening the route actually requires.
4

Finish the Building

The enclosure is finished and painted so the route reads as part of the room rather than a permanent construction repair. Work areas are closed out as finished spaces.

What this step establishes
  • Enclosure integrated with the room perimeter
  • Finished surfaces restored and painted
  • A move-in-ready result instead of an open work zone
Finished Plumbing Track enclosure integrated around a bathroom perimeter
The finished enclosure follows the bathroom perimeter as part of the room.
5

Handoff With Future Access

Planned access points stay part of the finished system. The building is handed back with a known enclosed route and flush access where service may be needed, instead of hiding the new system behind newly repaired walls.

What this step establishes
  • A known route after the project is complete
  • Flush access integrated into finished surfaces
  • Service access planned as part of the installation
Flush access panel in a finished Plumbing Track enclosure
A flush access point stays part of the finished enclosure for later service.

Step 1 of 5 · Assessment & Proposal

Manual navigation · the sequence does not auto-advance.

Why accessible plumbing matters ›

Apply it to your building

The exact route is determined by the building.

An assessment brings the existing pipe, occupied conditions, route constraints, access points, and finishing requirements into one building-specific installation plan.

Book an Assessment ›